大功率适配器 120W 150W

1、输入电压范围（ Input Voltage Range）：                              100Vac to 240Vac

2、输入频率（Input Frequency Range   ）                               47Hz to 63Hz

3、输入电压的谐波失真Input Voltage Harmonic Distortion                     £ 8%

4、效率（热身后1小时）Efficiency (warm up after 1 hour)                     ³ 85%

5、空载功耗No Load Power Consumption           240Vac / 0A load            £1W

6、输出额定电压Output Rated Voltage                                          12V

7、输出电流Output Current                                                  0~12.5A

8、输出电压Output Voltage Setting          电缆在直流输出端at the output end of DC cable                      11.4V~ 12.6V

9、输出电压纹波Output Voltage Ripple                                          £200mVp-p

10、湿度Humidity                                                            工作湿度：20% ~ 80%/存贮湿度 10% ~ 90%

11、 温度Temperature                                                          工作温度0 to 40C/存贮温度-20 to +80C

12、平均无故障时间MTBF                                                                     100000 hours

13、Turn-On Delay Time导通延迟时间       at 100Vac/150W load, output voltage shall

remain regulation在100Vac/150W负载，输出电压应保持调控                                    ≤ 2Sec

14、Hold Up Time           at 100Vac or 240Vac / 150W load, output    voltage shall remain regulation    ≥8 mS

保持时间                     在100Vac或240V交流/ 150瓦负载，输出电压应保持调节≥8毫秒

15、 Rise Time               at 100Vac or 240Vac / 150W load, DCoutput rise time from 5% to 95% of Vo   ≤ 80mS

上升时间                 在100Vac或240V交流/ 150瓦负载，DCoutput上升时间由5％至95％    ≤80mS

16、Load Transient Response     Output load step from ±50% change ofhalf load , S/R=0.5A/us, 100Hz &1KHz50% duty. Output voltage within spec.                                                                        11.4V~12.6V

17、Over Current Protection  过电流保护

When an internal fault occurs, or an

external fault is applied to the adapter,

such that an overload or short circuit is

applied to the output, the adapter shall shut

down. It will enter into normal condition if

the fault condition is removed.

Shutdown and no damage.

当发生内部故障，外部故障或应用到适配器，这样一过载或短路应用到输出，该适配器将关闭。如果故障排除。将进入正常状态，

18、 Over-Voltage Protection过电压保护

The adapter will enter into shut down that

means no output while over voltage

happened at output terminal that caused by

internal fault, the output trip voltage shall

not exceed 32 volts with a maximum

duration of 250 milliseconds. That will be

return to normal state by AC reset.

Shutdown and no damage

. 该适配器将成为关闭这意味着没有进入过电压，而输出端，通过内部发生故障所造成的输出，输出电压不得超过行程为250毫秒的最长期限32伏特。这将返回交流reset.Shutdown并没有损害到正常状态。

19、 Over Temperature Protection The adapter have thermal protection for

abnormal usage for/by parts failure. This

protection shall operate before rising to

reach to the cover-case’s deformation and

discoloration temperature.

The adapter shall be shut down and enter

latch-off mode. That will be return to

normal state by AC reset.

No broken, no smoke

过温保护的适配器有/零件故障异常使用的热防护。这种保护应上升到日前运作达到盖的变形和变色温度下适配器将被关闭，进入
闭锁模式。这将返回到正常状态交流。不能撞击，不能投入火中

20、尺寸（长x宽x高）Dimension (Length x Width x Height)                                        172mm*65mm*37mm

21、交流输入插座类型Input AC socket Type                                                       国标品字形