点击图片查看原图
- 产品品牌：力科
- 产品型号：9354AL/9354TM
- 通道数：4
- 外形尺寸：21x37x41cm
- 外形尺寸：21x37x41cm mm
数字存储示波器 LeCroy 9354AL/9354TM
厂家：美国力科 ( 21x37x41cm，13kg)
500M带宽，4通道 采样率最高可达2 GS/s 9354AL可达8M存储深度,9354TM可达2M存储深度 Innovative Peak Detect Mode Fully programmable via GPIB and RS-232-C Automatic PASS/FAIL testing Advanced Signal Processing Internal High Resolution Graphics Glitch, Pattern, Qualified, Interval, Dropout and Video Triggers 8-bit vertical resolution, 11 with ERES option DOS Compatible Floppy Disk, PCMCIA potable hard drive and Memory Card options采集系统
带宽(-3 dB)：DC to 500 MHz No. of Channels：4 CH No. of Digitizers：4 CH 最大采样率：2 GS/s 采集存储器：9354AL可达8 M,9354TM可达2M. 灵敏度：2 mV/div to 5 V/div, fully variable. Scale factors：A wide choice of over 12 probe attenuation factors are selectable. Offset Range：2.0 - 9.9 mV/div：± 120 mV10.0 - 199 mV/div：± 1.2 V
0.2 - 5.0 V/div：± 24 V
±20 V across the whole sensitivity range when using the AP 020 FET probe. DC Accuracy：< or equal to±2% full scale. 垂直分解度：8 bits. 带宽限幅器：30 MHz 输入耦合：AC, DC, GND. 输入阻抗：1 M Ohm//14 pF or 50 Ohms ± 1%. 最大输入：
1 M Ohm：250 V (DC+peak AC < or equal to 10 kHz)
50 Ohms：± 5 V DC (500 mW) or 5 V RMS
时基系统
Timebases：Main and up to 4 Zoom Traces. Time/Div Range：1 ns/div to 1000 s/div. Clock Accuracy：< or equal to 10 ppm Interpolator resolution：10 ps Roll Mode：Ranges 500 ms to 1,000 s/div. For > 50k points：10 s to 1,000 s/div. External Clock：< or equal to 100 MHz on EXT input with ECL, TTL or zero crossing levels up to 500 MHz with option 935XA-CKTRIG.触发系统
Trigger Modes：Normal, Auto, Single. Trigger Sources：CH1, CH2, Line, Ext, Ext/10 (9354：CH3, CH4), Slope, Level and Coupling for each can be set independently. Slope：Positive, Negative. Coupling：AC, DC, HF, LFREJ, HFREJ. Pre-trigger recording：0 to 100% of full scale (adjustable in 0.1 div increments). Post-trigger delay：0 to 10,000 divisions (adjustable in 0.01% increments). Holdoff by time：10 ns to 20 s. Holdoff by events：0 to 99,999,999 events. Trigger Bandwidth：Up to 500 MHz using HF coupling. Internal Trigger Sensitivity Range：± 5 div. EXT Trigger Max Input：1 M Ohm//15 pF：250 V (DC+peak AC < or equal to 10 kHz)
50 Ohms ± 1%：± 5 V DC (500 mW) or 5 V RMS EXT Trigger Range：±0.5 V (±5 V with Ext/10) Trigger Timing：Trigger Date and Time are listed in the Memory Status Menu.
SMART触发类型
Pattern：Trigger on the logic AND of 5 inputs - CH1, CH2, CH3, CH4, and EXT Trigger, (9350：3 inputs - CH1, CH2, EXT) where each source can be defined as High, Low or Don't Care. The Trigger can be defined as the beginning or end of the specified pattern. Signal or Pattern Width：Trigger on glitches as short as 1 nsec or on pulse widths between two limits selectable from < 2.5ns to 20s. Signal or Pattern Interval：Trigger on an interval between two limits selectable from 10ns to 20s. Dropout：Trigger if the input signal drops out for longer than a time-out from 25ns to 20s. State/Edge Qualified：Trigger on any source only if a given state (or transition) has occurred on another source. The delay between these events can be defined as a number of events on the trigger channel or as a time interval. TV：Allows selection of both line (up to 1500) and field number (up to 8) for PAL, SECAM, NTSC or non-standard video.公司联系方式
- 北京市北方思源电子技术中心 [加为商友]
- 联系人刘(女士)
- 地区北京
- 地址海淀区大柳树路富海中心
