二手标量网络分析仪54147A ANRITSU 彭海军

二手标量网络分析仪54147A ANRITSU 彭海军

　   54100A系列网络分析仪可提供设备特性。设备包括：放大器、天线、适配
器、RF电桥、电缆、波相传输线、接收器、衰减器、VCO、开关、耦合器、过滤
器等。先进的软硬件特性可加速生产力和提高准确性。结合自动波段搜索功能
加快调节速度。低源同步和高指向性SWR自动测试仪确保准确。
★快速准确的测量传输、返回损耗及精确性返回损耗、SWR、群延迟、绝对功率
  和距离误差。
★晶体源特别稳定和准确。
★内置自动化特征包括距离误差
★内置磁盘驱动
★结实可靠的机箱
★传输收益（损耗），群延迟和功率测量
★传输及返回损耗（或SWR）
★适配器、衰减器、终端、耦合器及RF电桥
★54107A 纯量测试系统（0.001-1.5GHz）
特  点:
    54100A系列网络分析仪可提供设备特性。设备包括：放大器、天线、适配
器、RF电桥、电缆、波相传输线、接收器、衰减器、VCO、开关、耦合器、过滤
器等。先进的软硬件特性可加速生产力和提高准确性。结合自动波段搜索功能
加快调节速度。低源同步和高指向性SWR自动测试仪确保准确。
★快速准确的测量传输、返回损耗及精确性返回损耗、SWR、群延迟、绝对功率
和距离误差。
★晶体源特别稳定和准确。
★内置自动化特征包括距离误差
★内置磁盘驱动
★结实可靠的机箱
★传输收益（损耗），群延迟和功率测量
★传输及返回损耗（或SWR）
★适配器、衰减器、终端、耦合器及RF电桥
★54107A 纯量测试系统（0.001-1.5GHz）
技术指标:
     Analyzer Measurement modes Transmission(dB),return loss(dB),SWR
(linearSWR),optiona group delay(ns),power(dBm)precision return loss
(dB) and optionaldistance-to-fault Dynamic range -55 to +16dBm,
autozeroing with DC detection Inputs Three,two standard inputs,A and
B,with optionathird reference channel,R(Option 5) Display channels
Two channels are used to select and simultaneouslydisplay any two
inputs fromA,B,or R.The inputs can also be displayed asratios A/R or B/R.
Scale resolution 0.1 to 10dB(m) per division in 0.1dB steps Cursor
functions Searches for trace maximum,minimum,dB level,dBbandwidth,next
marker and active marker Averaging 2,4,8,16,32,64,128,or 256 Limit
lines Two limit ines,either single value or multilevel segmented,for
each trace.Segmented lines may be made from up to 10individually
editable segments.
Auto-zero Performs an AC modulation cycle and lowlevel calibration
during sweeper ratrace Save/Recall Thirteen sets of front panel set-
UPS andthirteen sets of trace memory can be stored in non-volatile
instrument memory.
Trace mask A swept frequency measurement can be storedto a graticule
trace mask for visual comparison to later measurements.
Disk drive Built-in 3.5 inch,1.44MB floppy disk drive
Autosave Automatically increments the trace datafile name and reference
 number during successive data storage operationsto the DOS disk
Source Frequency range 1Mhz to 110GHz,model dependent
Alternate sweep Sweep alternately between frequenc yrangesset differently
for channel 1 and channel 2 CW Provides single frequency output(both
channelsturned off) Frequency resolution Rf Model(54107A,54109A,54111A):1
0kHz,Microwavemodels:100khz Output power Maximum guaranteed levelled
output poweris model dependent.
Reverse power protection UP to 5 Watts.Limited to 1 Watt with attenuatoroption
Appli-cation function Min/Max hold Save the minimum and maximum values
of successivesweeps or the combination of the two Cursor functions
Automatic cursor seach updates the bandwidth,minimum,ormaximum levels
 of the displayed trace.
Compression test automation Determines the gain compression point
overthe operating freqeuncy range of an ampliffier by successively
incrementingthe source power and measuring the amount of compression
until a preset"X"dBlimit is exceeded.
Self test Performs a self test every time power isapplied or when
SELF TEST pushbutton is pressed.If an error is detected,adiagnostic
 CODe appears,identifying the cause and location of the error.
General Operating temperature 0°to 50℃
Power 48 to 400Hz,300VA
Mass 18kg(39lb.)
Printer Parallel printer interface is compatiblewith the Canon BJ30,
Bj200e,and most Epson FX-compatible printers.
Transit case Hard shell case with custom foam inserts,PN:760-183
EMC Meets European community requirements forCE marking
订货信息 Model/Order No. Name
Option 1 Options
Rack mounting with slides
Option 2 70dB RF step attenuator
Option 2A 70dB,20Ghz MW step attenuator
Option 2B 70dB,26.5GHz MW step attenuator
Option 2C 70dB,40GHz MW step attenuator
Option 2D 70dB,50GHz MW step attenuator
Option 4 75Ω source output(available to 3.0GHz)
Option 5 Add reference channel
Option 6 Add external levelling
Option 7 Internal distance-to-fault software
Option 8 Internal relative group delay software
Option 12 Add front panel cover
Option 13 Add front mounted handles
Option 16 +15V DC supply for millimeter wave source modules(availablewith
<20GHz models only)
Option 25 Maintenance manual
Option 26 Extra operation and GPIB programming manual
Option 33 Canon printer