温升记录仪

The IDL 100 can directly accepts 8 analog inputs and up to 60 more from
remote Sensor Modules via RS 485. Inputs can be configured to measure
current, voltage, resistance / Pt100 (2, 3, and 4 wire) and thermocouple
inputs. The 6 digital channels can be configured as input (status, counter,
frequency) and/or outputs (status, alarm) depending on the application. All
values can be stored on internal RAM or on the optional PCMCIA memory
card. Logged data can be uploaded to a PC via an RS 232 interface,
modem GSM, or TCP/IP. Inputs can be linearized, formatted, transmitted
over a network, and used in advanced mathematical analysis.
The autocall feature enables the IDL 100 to communicate back to the
operator according to predefined conditions. This ensures that the potential
for data loss is minimized. Stored data can be uploaded to a PC via an RS
232 or RS 485 interface using Profibus layer 2, Modbus-RTU, or ASCII.

8 universal analog inputs
Voltage, current, resistance, Pt100, Pt1000, thermocouples
6 general-purpose digital I/O
Status, counter, frequency measurement
256 kB internal RAM
Data logging
PCMCIA Slot
2 MB at PCMCIA SRAM memory or 8 MB at PCMCIA Flash memory
RS 485 fieldbus interface
Profibus layer 2, Modbus-RTU, ASCII

Voltage, current, resistance, Pt100, Pt1000, thermocouples, bridges
2 general-purpose digital I/O
Status, frequency, counter, control signals
Analog output
Output of measured and calculated values, PID controller
Logically and mathematically functions 
Complex combination of the channels
RS 485 fieldbus interface

8 analog inputs, 16 bit ADC
Voltage, current, resistance, Pt100, Pt1000, thermocouple
6 digital in/outputs
Status, signal acquisition, control signals
256 kB internal RAM
PCMCIA Slot
Up to 2 MB with PCMCIA SRAM memory card or up to 8 MB with PCMCIA Flash memory card
RS 232 and RS 485 fieldbus interface
Profibus level 2, Modbus-RTU, ASCII