| 规格（Item No) | TA-41k |
| 显示范围 | 9999hr~99.99 second |
| Display Range |
| 设定范围 | 1~9999 |
| Setting Range |
| 字型尺寸 | Count LED0.56″(orange)Preset LED0.3″(Green) |
| Character Height |
| 计数输入 | 有接点输入无接点输入 |
| Input Signal Mode | Contact input:25Hznon-contact input:3KHz(ON-OFF ratio1:1 |
| 输出方式 | 1Relay output(la,b AC 250v/5A) |
| Output System |
| 输出时间 | 0.1~9.9 seconds(variable) |
| Output Hold time |
| 复归方式 | Extemal,Manual,Auto Reset |
| Reset Syetem |
| 输入信号 | NPN,open collector |
| Input level |
| 停电记忆 | EEPROM memory keep ten years |
| Power Failure Memory |
| 信号电源 | DC12v?5%Max electric current caPACity 100mA |
| DC Out for Sensor |
| 电源电压 | AC 110v/220v?15%50Hz/60Hz |
| Power Supply |
| 消耗电力 | 5.5VA |
| Power Consumption |
| 耐温湿度 | —10℃~ 50℃35%~85%RH |
| Operating Temperatur Humidity |
| 尺寸规格 | 72mm*72mm*145mm(版面开孔Mounting flush dimension:68mm*68mm) |
| External Dimensions |
| Switch Setup | 一、R:回归(RETURN)(SW2-1 ON) |
| 计数值等於设定值时Relay ON计时继续, |
| 待T时间后(面板Timer调整)Relay Return(复归),计时值归零 |
| N:手动(Manual)(sw2-1 OFF),Relay ON, |
| 计数值等於设定值时,Relay ON, |
| 停止计时,直到手动或外部复归 |
| Relay才OFF. |
| 2.时间功能选择 Time Function Selection(SW之2,3,4, |
| ※注意:在要改时间功能选择后,必须切掉电源再重新开机. |
| 计时方式: |
| 当第9(START)和第12(OV)短路即开始计时,开路时,则停止计时.关机再开机时具带有停电记忆作用 |
点击图片查看原图
未注册
